Guide to Installing Ram Memory

At this point it will serve little purpose to become too deeply
involved in the technical jargon of Memory modules, such as Dimms, Simms, Dram
and SDRam. Suffice to say for our purposes, all ram modules fit into
memory slots on the motherboard. 486 motherboards use either 30pin simms
or 72 pin simms. Pentium motherboards require at least 72pin simms or
168pin Dimm SDram modules.

30pin Simm
found on older 386/486 motherboards

72pin Simm
found on later 486 systems/early Pentium systems

168pin Dimm
latest version of Ram Memory, often called: PC100 and SDRam

The ram slots are typically easy to insert and uninstall
memory. Memory modules fit in only one direction, with the Simms
note the small cut on one side of the module, it corresponds with a tab in the
memory holder. In using Dimms, 168pin ram, they have a distinctive pattern
of three areas on the bottom of the module that must be aligned in order for the
module to fit into the holder. Once a Dimm is in place the side clamps
lock into place. This is the same with Simm modules, the small clips that
hold them in place will lock once the module is properly installed.

On rare occasions the bottom of the module will not make good
contact with the holder. You can remove any tarnish or other coatings that
infringe upon good contact with the eraser of a pencil or rub them with a small
amount of alcohol.

INSTALLATION OF RAM MODULES
Simms:

When installing SIMMs, most manufacturers require the module to be
inserted at a 45 degree angle, then "snapped" forward to the correct position.
Most Pentium systems require matched pairs of modules.
Dimms (SDRam):

Unlike SIMM installation, DIMMs may be "snapped" directly into the
socket. Some DIMM sockets have minor physical differences. If your module
doesn't seem to fit, please do not force it into the socket... attempt to
return the module for one that fits your motherboard.

Another issue that occurs is the use of mis-matched ram. In
the case of Pentium or better motherboards and using Simms, the simm must be
installed two at a time, matched pairs of ram.

If in fact the memory holders on the motherboard can become
damaged or unable to properly seat memory in rare instances. The only hope
for such problems is replacing the motherboard.